Mitsubishi Electric Q01UCPU User Manual page 132

(3) Executing method
(a) Using a RUN contact
Set a RUN contact in the PLC system tab of the PLC parameter dialog box.
The settable device range is X0 to 1FFF.
The remote RUN/STOP operation can be performed by turning on/off the set RUN contact.
• When the RUN contact is turned off, the CPU module status changes to RUN.
• When the RUN contact is turned on, the CPU module status changes to STOP.
CPU module: RUN/STOP status
(b) Using a programming tool
Select [Online] [Remote Operation] "RUN" or "STOP".
(c) Using an external device in the MC protocol
Use MC protocol commands. For commands, refer to the following.
MELSEC-Q/L MELSEC Communication Protocol Reference Manual
External device
(d) With link dedicated instructions of the CC-Link IE module or MELSECNET/H module
The remote RUN/STOP operation by link dedicated instructions of the CC-Link IE module or MELSECNET/H
module can change the RUN/STOP status of the CPU module.
For details, refer to the following.
Manual for each network module
130
Step 0
OFF
RUN contact
RUN
Step 0
ON
Remote STOP
OFF
command
OFF
Remote RUN
command
RUN
RUN/STOP status
Step 0
END
ON
STOP
STOP status
END
STOP
STOP status
END
0
Step 0 END
0
ON