Assignment Of The Extension Port Connected To The Tvp; Synchronisation Of Communication Between Kx-Td500 System And The Tvp - Panasonic KX-TD500 Programming Manual

Configuration

4. Assignment of the extension port connected to the TVP.

Select in "Port No." menu the extension port number of the card (DLC / DHLC) to which the
TVP (DPT) jack is to be connected. This menu is displayed only when the attribute of the port
is assigned to "VPS (DPT)" at step 2.
After "Port No." selection, assign "DN" and "Extension Group No." for the port.
Save the data changes by clicking
Then set "Port Status" to "INS (In-Service)."
Jack No.1 must be assigned, because the port is used as the channel to control the VPS.
5. Synchronisation of the communication between the KX-TD500 System and the TVP.
The KX-TD500 System begins synchronisation with the VPS when the step 4 is done.
The "Power" LED of the VPS begins flashing at the same time. The LED will turn on after the
synchronisation is completed. It takes for about 30 seconds to 1 minute to be able to use the
VPS system. It depends on the VPS model and the port number you set up.
Parameter
Default
Value Range
Description/Function
Reference
Parameter
Default
Value Range
Description/Function
Reference
20
.
TVP No.
1
1- 8
Specifies one of the Panasonic Voice Processing Systems (VPSs)
connected to the KX-TD500 system, which you are going to
programme.
• 1.3 System Features (F/G)
– Integration, VPS
• 1.2 Slot Assignment (P/G)
VPS Card
None
None, XXX : YYY [XXX : Card No. (101-314), YYY : Card Type]
Specifies the physical number of DLC / DHLC card to which VPS
is connected as extensions.
Note
• The first DLC / DHLC card will support jacks 1 to 8 of the
first TVP300 system. A second card will support jacks 9 to
12 of the TVP300 system. A third and fourth card are needed
to support a second TVP300 system which is fully
configured.
• 1.3 System Features (F/G)
– Integration, VPS
• 1.2 Slot Assignment (P/G)
Programming Guide