Warning Messages (Wxxxx) - Panasonic KX-TD500 Programming Manual

11.2 Warning Messages (WXXXX)

Code
W0001 Save system data?
Some parameters on the screen were changed. A click on "OK" or a screen switch was
attempted without saving data.
W0002 The status of the port is In-Service (INS). Would you like to continue?
When the status of a port is In-Service (INS), and you change some parameters (screens
of "1 Configuration"), the port is reset. A call in progress will be dropped.
W0003 Save system data before Copy?
Modified parameters without saving are not effective for Copy feature.
W0005 Save data file?
Tried to close, exit or open another file without saving data in the Batch mode
(although parameters were changed).
W0006 Mismatch between PC software version and PBX software version. Proceed to
load matching PC software?
PC software (Maintenance Console software) is not compatible with the current KX-
TD500 software. Load the appropriate PC software into your PC. (Then connect your
PC to the KX-TD500 again.)
W1001 Change the card (XXX:YYY) status?
Please confirm whether or not to execute OUS (Out-of-Service) / INS (In-Service)
command to the card "XXX:YYY" (XXX: Slot No., YYY: Card Type).
The OUS (Out-of-Service) / INS (In-Service) command to the card is effective to the
whole ports of the card.
W1002 Change the status of port (XXXXX)?
Please confirm whether or not to execute OUS (Out-of-Service) / INS (In-Service)
command to the port "XXXXX" (XXXXX: port physical number).
W1003 Make sure the card is "OUS," before changing the "Card Properties."
If the card is already "OUS" to change the properties or to just view "Card Properties,"
click "OK." To change the card to "OUS," click "Cancel."
W1004 DTMF Caller ID code must not exceed 16 characters. Truncate it?
Truncate means that the leading 16 characters are saved and the rest are deleted.
W2001 Would you like to upload a language data?
Specifies whether or not you upload the language data after uploading the system data
in off-line mode. If you click "OK," the "Language Data Selection" dialogue box is
displayed and then uploading of the "Language Data" file can be executed.
W3001 PBX code must not exceed 4 digits. Truncate it?
Truncate means that the leading 4 digits are saved and the rest are deleted.
Programming Guide
Message
Description
Programming Error Messages
351