Panasonic KX-TD500 Programming Manual page 344

Programming Error Messages
Error Code
E1037 Cannot change the status of the port.
Cannot change the status of the SLT port because the PT port is activated as a "Parallel
Mode" extension. Please change the PT port status to "XDP Mode" and then press
"Apply."
E1038 You have exceeded the shelf limit of extension ports.
There is a limit of 192 extension ports per shelf when using PLC, HLC, SLC, SLC-M,
OPX, DLC, DHLC or ESLC cards. Please de-assign one card and try again.
E1039 You have exceeded the shelf limit of SLT ports.
There is a limit of 160 SLT ports per shelf when using HLC, SLC, SLC-M, DHLC or
ESLC cards. Please de-assign one card and try again.
E1050 The slot next to PRI card must be empty.
Please remove and re-assign the card that is installed next to a PRI23 / PRI30 card. A
PRI23 / PRI30 card must go into slot no. 1, 3, 5, 7, 9, 11 or 13.
E1051 E1 card should be assigned to the slot no. 1, 5 or 9.
E1 card should be assigned to the slot no. 1, 5 or 9 of basic shelf, expansion shelf 1 and
expansion shelf 2.
E1052 The slot next to an E1 card must be empty.
Please remove and re-assign the card that is installed next to an E1 card. An E1 card
must go into slot no. 1, 5, or 9.
E1053 PRI card must be assigned to an odd numbered slot.
PRI card should be assigned to the odd numbered slot of basic shelf, expansion shelf
1 and expansion shelf 2.
E1054 The status of the card must be "OUS (Out-of-Service)."
When you change the card properties of PRI23, PRI30 or BRI card, the status must be
OUS (Out-of-Service)."
E1055 Number of PC Console limit (8 consoles) per system exceeded.
There is a limit of 8 PC consoles per system.
E1056 Value of Max. must be larger than value of Min.
Detection time value of "[Tone-ON Time/Tone-OFF Time] Max." must be larger than
that of "[Tone-ON Time/Tone-OFF Time] Min."
E1057 One card cannot support both VPS (DPT) and PC Console connections; choose
one.
If a PC Console is already assigned to an extension port on a DLC or DHLC card, a
VPS (DPT) cannot be assigned to the other extension ports on the same card and vice
versa. Please assign a PC Console and a VPS(DPT) to a different DLC or DHLC card
each other.
E1058 Assign ISDN Ext. under "1-8 BRI Port Assignment."
Please set "Type" in "1-8 BRI Port Assignment" screen to "EXT" before programming
"4-6 ISDN Extension Line" parameters.
344
Error Message
Description
Programming Guide