HP MSR1003-8S Command Reference Manual page 154

Status
PoE Power Supply 2:
Manufacturer
Type
Status
Table 29 Command output
Field
Chassis 1
Slot 1
PoE Current Power
PoE Average Power
PoE Peak Power
PoE Max Power
PoE Nominal Power
PoE Current Electric Current
PoE Current Voltage
PoE Lower Input Threshold
PoE Upper Input Threshold
PoE Lower Output Threshold
PoE Upper Output Threshold
PoE Hardware Version
PoE Software Version
PoE Power Supplies
Manufacturer
Type
Status
: Normal
: Tyco Electronics Com
: PSE2500-B
: Normal
Description
Information for member device 1. (Distributed devices in IRF mode.)
Information for member device 1. (Centralized devices in IRF mode.)
Current PoE power.
Average PoE power.
Peak PoE power.
Maximum PoE power.
Nominal PoE power.
Current PoE current.
Current PoE voltage.
AC input under-voltage threshold.
AC input over-voltage threshold.
DC output under-voltage threshold.
DC output over-voltage threshold.
PoE hardware version number.
PoE software version number.
Number of PoE power supply units.
Manufacturer of the PoE power. This field displays NONE if the device
cannot obtain manufacturer information.
Type of the PoE power. This field displays NONE if the device cannot
obtain type information.
PoE power status:
•
Normal—The PoE power supply is operating correctly.
•
Absent—The PoE power supply is not present.
•
Off—The PoE power is turned off.
•
Active—The active PoE power supply is operating correctly.
•
Standby—The standby PoE power supply is operating correctly.
•
Balanced—The PoE power supply is operating in load balancing
mode.
•
Redundant—The PoE power supply is operating in redundancy
mode.
•
Alarm—An alarm was triggered.
•
Faulty—A fault occurred.
143