Lsr-Path - HP MSR1003-8S Command Reference Manual

Views
UDP tracert operation view
Predefined user roles
network-admin
Parameters
value: Specifies the TTL value in the range of 1 to 255.
Examples
# Set the TTL value to 5 for the UDP packets in the start round.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type udp-tracert
[Sysname-nqa-admin-test-udp-tracert] init-ttl 5

lsr-path

Use lsr-path to specify a loose source routing (LSR) path.
Use undo lsr-path to restore the default.
Syntax
lsr-path ip-address&<1-8>
undo lsr-path
Default
No LSR path is configured.
Views
Path jitter operation view
Predefined user roles
network-admin
Parameters
ip-address&<1-8>: Specifies a space-separated list of up to eight IP addresses. Each IP address
represents a hop on the path.
Usage guidelines
The path jitter operation first uses tracert to detect each hop to the destination. It then sends ICMP echo
requests to measure the delay and jitters from the source to each node. If multiple routes exist between the
source and destination, the operation uses the path specified by using lsr-path command.
Examples
# Specify 10.1.1.20 and 10.1.2.10 as the hops on the LSR path for the path jitter operation.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type path-jitter
[Sysname-nqa-admin-test- path-jitter] lsr-path 10.1.1.20 10.1.2.10
40