Ntp Commands; Display Ntp-Service Ipv6 Sessions - HP MSR1003-8S Command Reference Manual

NTP commands

NTP is supported on the following Layer 3 interfaces:
Layer 3 Ethernet interfaces.
•
Layer 3 Ethernet subinterfaces.
•
Layer 3 aggregate interfaces.
•
• Layer 3 aggregate subinterfaces.
VLAN interfaces.
•
Tunnel interfaces.
•
RPR logical interface.
•

display ntp-service ipv6 sessions

Use display ntp-service ipv6 sessions to display information about all IPv6 NTP associations.
Syntax
display ntp-service ipv6 sessions [ verbose ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
verbose: Displays detailed information about all IPv6 NTP associations. If you do not specify this
keyword, the command displays only brief information about the IPv6 NTP associations.
Examples
# Display brief information about all IPv6 NTP associations.
<Sysname> display ntp-service ipv6 sessions
Notes: 1 source(master), 2 source(peer), 3 selected, 4 candidate, 5 configured.
Source:
Reference: 127.127.1.0
Reachabilities: 1
Last receive time: 6
Roundtrip delay: 0.0
Total sessions : 1
[125]3000::32
Clock stratum: 2
Poll interval: 64
Offset: -0.0
Dispersion: 0.0
82