Resolve-Target - HP MSR1003-8S Command Reference Manual

Views
DHCP/DLSw/DNS/FTP/HTTP/SNMP/TCP/voice operation view
ICMP/UDP echo operation view
UDP jitter operation view
UDP tracert operation view
Predefined user roles
network-admin
Parameters
path-change: Sends a trap when the UDP tracert operation detects a different path to the destination.
probe-failure consecutive-probe-failures: Sends a trap to the NMS if the number of consecutive probe
failures in an operation is greater than or equal to consecutive-probe-failures. The value range for the
consecutive-probe-failures argument is 1 to 15. The system counts the number of consecutive probe
failures for each operation, so multiple traps might be sent.
test-complete: Sends a trap to indicate that the operation is completed.
test-failure: Sends a trap when an operation fails. For operations other than UDP tracert operation, the
system counts the total number of probe failures in an operation. If the number reaches or exceeds the
value for the cumulate-probe-failures argument, a trap is sent for the operation failure.
cumulate-probe-failures: Specifies the total number of probe failures in an operation. The value range for
the cumulate-probe-failures argument is 1 to 15. This argument is not supported by the UDP tracert
operation.
Usage guidelines
The UDP jitter and voice operations support only the test-complete keyword.
The UDP tracert operation supports the path-change, test-complete, and test-failure keywords.
Examples
# Configure the system to send a trap if five or more consecutive probe failures occur in an ICMP echo
operation.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] reaction trap probe-failure 5

resolve-target

Use resolve-target to specify the domain name for the DNS operation.
Use undo resolve-target to restore the default.
Syntax
resolve-target domain-name
undo resolve-target
Default
No domain name is configured.
65