Action Switchover; Action Syslog - HP MSR1003-8S Command Reference Manual

action switchover

Use action switchover to add an active/standby switchover action to a monitor policy.
Use undo action to remove an action.
Syntax
action number switchover
undo action number
Default
Monitor policies do not contain any actions.
Views
CLI-defined policy view
Predefined user roles
network-admin
Parameters
number: Specifies an action ID in the range of 0 to 231.
Usage guidelines
This command does not trigger an active/standby switchover in either of the following situations:
The device has only one MPU.
•
• The standby MPU is not in up state.
You can configure a series of actions to be executed in response to the event specified in a monitor policy.
If two actions have the same ID, the most recent one takes effect.
EAA executes the actions in ascending order of action IDs. You must make sure the execution order is
correct when you add actions to a policy.
Examples
# Configure an action for the CLI-defined policy test to perform an active/standby switchover.
<Sysname> system-view
[Sysname] rtm cli-policy test
[Sysname-rtm-test] action 3 switchover

action syslog

Use action syslog to add a Syslog action to a monitor policy.
Use undo action to remove an action.
Syntax
action number syslog priority level facility local-number msg msg-body
undo action number
Default
Monitor policies do not contain any actions.
290