Toshiba Tosvert VF-S15 Instruction Manual page 137

6.5.2
f102 : Speed reach detection band
 Function
[Parameter setting]
Parameter setting of designated frequency and detection band
Title
f102
Parameter setting of output terminal selection
Title
f131
Setting value 7 is reverse signal.
Note: Set f132 to output to FLA-FLC-FLB terminals and f130 to RY-RC terminal.
6
Output of designated frequency reach signal
When the output frequency becomes equal to the setting by designated frequency  f102, an ON
or OFF signal is generated.
Function
Speed reach detection band
Function
Output terminal 0-255
selection 2A (OUT) (Refer to section 11.7.)
Designated frequency  
Setting frequency
Designated frequency  
Output frequency attainment signal
: OUT-NO terminals
Inversion of output frequency
attainment signal
Adjustment range
0.0-fh (Hz)
Adjustment range
6: RCH (Output frequency attainment signal
(acceleration/deceleration completed))
Output frequency [Hz]
0
F-26
E6581926
Default setting
2.5
Default setting
Time [s]
ON
OFF
ON
OFF