Fcc Warning (Federal Communications Commission) - ABB VSN300 Product Manual

1 - Introduction and general information
F
CC Warning (Federal Communications Commission)
This devices complies with Part 15 of the FCC standard Operation is
subject to the following conditions:
1. This device cannot cause harmful disturbances.
2. The device has to accept any disturbance it receives, including
disturbance which could compromise correct device operation.
This equipment has been tested and is compliant with the limits for digital
devices of Class B, pursuant to Part 15 of the FCC standard. These
limits are designed to provide a protection against harmful disturbances
in residential installations. This equipment generates, uses and emits
radio-frequency energy and, if not installed and used in accordance with
the instructions, can cause harmful damage to radio communication.
However, the is no guarantee that disturbances in a particular installation
may occur. If this equipment causes harmful disturbances to radio or
television reception which could be determined when the equipment is
switched on and off, the user is invited to attempt to correct the disturbance
with one of the following measures:
- Reposition or change the direction of the reception antenna.
- Increase the distance between the equipment and the receiver.
- Connect the device to a different circuit socket to that one used for the
receiver.
- Contact the dealer or a radio / television technician for assistance.
RF exposure. This devices complies with Part 2,1091 of the FCC standard
for uncontrolled environments. This equipment must be installed and
used with a minimum distance between the antenna and the user of at
least 20 cm.
Refer to the specific section which describes the procedures for
integrating and using this device inside a fixed inverter.
Any modifications made to this equipment, unless expressly authorized
by the manufacturer, may invalidate FCC authorization for using the
equipment.
- 11 -