Local Update - ABB VSN300 Product Manual

L
ocal update
Files with the .tib or .ben extension
must be loaded into a local folder
on the Wi-Fi device which the
user is using to navigate the user
interface pages of the VSN300
board
The file upload can fail for a number of different reasons, usually due to the Wi-Fi network
connection. Make sure that the device used for the upload is quite close to the router or the
inverter and that the Wi-Fi signal is not too weak. Also ensure that the file you are attempting
to transfer is the file which has been officially released by ABB and that it is not corrupted. The
«UPDATE» key is disabled until the file has been transferred completely. If an error continues
to appear, contact ABB technical department for further information.
Choose from Firmware update via
access to the ABB remote servers
or by loading into the internal
memory of the local device
Upload from the local device
and update the Firmware of the
VSN300 board
Upload from the local device
and update the Firmware of the
Upload the file containing the
updated Firmware from the local
device and start the transfer
As an alternative to the procedure using the Internet, or for boards
configured in «AP Mode», the board or the inverter can be updated via
an upload from a local device.
To upload the .tib or .ben file of the Firmware click on «Upload FW file».
Once the user has reached the local folder containing the .tib or .ben file,
select this file and start transferring it into the memory of the VSN300
board by clicking on «OPEN».
If the transfer fails, the message «File Upload failed» will appear below
«Upload FW file».
Once the upload has been completed successfully, the update stage can
be launched, i.e. the new FW can be installed by clicking on «UPDATE».
inverter
- 64 -
7 - Operation