Led Behaviour - ABB VSN300 Product Manual

L
ED behaviour
As soon as the inverter is switched on, the VSN300 board is also
automatically powered, in this condition the led 4 emits a red intermittent
light.
The first time the board is switched on, it acts like an access point («AP
Mode»). After a few seconds both led 5 and 6 flash alternately emitting a
green and yellow light and then stabilise in the following condition where:
Led 4: flashing red
Led 5: off
Led 6: yellow (steady)
After having connected the VSN300 board to the Wi-Fi router, it stops
operating in «AP Mode» and begins to operate in «Station Mode».
In «Station Mode», the leds of the board modify and behave as follows:
Led 4: flashing red
Led 5: green (steady)
Led 6: off
LED

Led behaviour

Flashing
4
Green and Yellow flashing
5 6
Green (steady)
5
Yellow (steady)
6
Green and Yellow flashing 3 times
5 6
together
- 41 -
6 5 4
Description
Board powered
Start phase
Connected to a local Wi-Fi network
«Access Point Mode» enabled
Inverter Serial Number acquired
6 - Instruments