Table of Contents
Advertisement
Installation Manual – BTS3606 Cabinet Installation
Airbridge BTS3606&3606A CDMA Base Station
6)
Re-measure the lines to confirm the accuracy of each hole. Figure 2-16
illustrates the positions of installation holes for U-bar supports.
(1) M12 expansion bolt
Figure 2-16 Installation hole positions of U-bar supports
7)
Place the lower support on the floor according to the cabinet layout.
8)
Mark the positions of four connecting holes of the cabinet (each cabinet has four
connecting holes) on the floor under the lower support.
9)
Remove the lower support.
10) Use the φ20 bit to drill holes through the marked places.
II. Preparing U-bar Support
To prepare the U-bar support, proceed as follows:
1)
Drill installation holes for the cabinet and fixing holes on the U-bar, as shown in
Figure 2-16 and Figure 2-17.
(2) Outline of the cabinet
Huawei Technologies Proprietary
2-19
Chapter 2 Installing Cabinet Assemblies
(3) Front face of the cabinet
Advertisement
Table of Contents
