Installation Manual – BTS3606 Cabinet Installation
Airbridge BTS3606&3606A CDMA Base Station
Figure 2-4 U-bar support
II. Assemblies
None.
III. Installation Method
You need to prepare the U-bar support on the site. For the specific method, see
section 2.6 "Installing Assemblies on Cement Floor with Poor Bearing Capacity".
IV. Length
Determine the length of the U-bar support as needed.
2.3 Cabinet Layout Principle
The principle of cabinet layout is as follows:
The space between the cabinet back and the wall must be greater than 0.6m (24
in.).
The cabinet side can be installed against the wall.
The path with the width no less than 0.8m (32 in.) must be reserved in front of
the cabinet.
The cabinet must be positioned as close as possible to the feeder window to
reduce the length of the feeder cable.
It is recommended to lay three BTS cabinets in a row, as shown in Figure 2-5, one as
the main cabinet, the rest as auxiliaries.
Huawei Technologies Proprietary
2-5
Chapter 2 Installing Cabinet Assemblies