Panasonic KX-NS1000 Programming Manual page 23

Notice
•
When connecting the PC to the MNT port, if the PC is set to obtain the IP address automatically,
the IP address of the PC will be set to an appropriate IP address to establish a connection to the
PBX. For more information about the connection procedure, refer to "5.2 PC Connection" in the
Installation Manual.
2.
Access Web Maintenance Console:
MNT Port connection:
Launch your Web browser and in the address bar, enter one of the following addresses exactly as shown:
–
223.0.0.1
or
–
http://kx-ns1000.
Note
•
If entering "http://kx-ns1000.", be sure to include the period at the end as shown.
•
If connecting using 223.0.0.1 takes a long time, configure a static IP address for the PC.
LAN or VPN connection:
Launch your Web browser and input the IP address of the PBX followed by the Web Maintenance Console
port number into the address bar. The input method will differ according to the PC's connection to the PBX.
The default IP address for the LAN port of the PBX is 192.168.0.101, and the default Web Maintenance
Console port number is 80. Accordingly, the address to enter to connect to the PBX for the first time will
be as follows (enter the address exactly as shown):
http://192.168.0.101
Internet connection (SSL Connection):
When the PC is accessing the PBX from a connection over the Internet, the use of SSL is strongly
recommended. When using an SSL encrypted connection, the default port is 443. The format of the address
to enter to connect to the PBX using an SSL encrypted connection will be as follows:
https://xxx.xxx.xxx.xxx:yyy
•
"xxx.xxx.xxx.xxx" is the IP address of a device that can be accessed from the Internet, such as the
IP address of a network router.
•
"yyy" is a port number. The network router's port forwarding settings must be configured so that traffic
arriving at port "yyy" is forwarded to the correct IP address and port of the PBX in the LAN.
•
Port forwarding settings must specify the IP address and the port number of the network router
("xxx.xxx.xxx.xxx:yyy") to transfer the packets to the PBX in the LAN, so that the packets sent to the
global IP address and specified port of the router will be transferred to the IP address and specified
port of the PBX in the LAN.
•
Note the usage of "https" instead of "http".
•
If you connect to Web Maintenance Console using SSL, a security alert window is displayed. Follow
the prompts to install a security certificate. The procedure may vary according to your browser.
Note
•
The IP address and Web Maintenance Console port number for the PBX can be changed from
their default values. If settings for the LAN port's IP address or port number have been forgotten,
connect using the MNT port connection as described above and confirm the LAN port's IP address
in 28.1 Network Service—[1] IP Address/Ports—Basic Settings, and the port in 28.2.3 Network
Service—[2-4] Server Feature—HTTP.
•
You can also connect to the PBX in On-line mode using the Off-line Web Maintenance Console
Programme Launcher. For details, see Connecting in On-line Mode using the Programme
Launcher in 1.2.2 PC Programming Using Off-line Mode.
1.2.1 Starting Web Maintenance Console
PC Programming Manual 23