12.1.5
Mounting
In order to install the DRIVE-CLiQ cabinet gland, you must make a cutout in the control
cabinet panel as shown in the diagram below.
Figure 12-3
Mounting
1. Insert the component from the outside of the control cabinet through the opening in the
2. Fix the DRIVE-CLiQ cabinet gland to the outer control cabinet panel using two M3 screws
SINAMICS S120 Combi
Manual, Edition 07/2012, 6SL3097-4AV00-0BP3
Cut-out for the cabinet
control cabinet.
and two nuts. In order to ensure good electromagnetic compatibility, a good electrical
connection must be established between the DRIVE-CLiQ cabinet gland and the cabinet
panel over a large surface area.
Accessories
12.1 DRIVE-CLiQ cabinet bushing
231