Hitachi AMS 2100 Hardware Manual page 170

2. Pull all the Fibre Channel cables into the rack, passing them through an
opening for cables on the bottom plate of the rack.
3. Using the reusable cable ties provided, bind the cables together and
fasten them securely to the rack at enough places to keep the cables
close to the rack over their entire length. Leave extra length for each
cable so that the connectors will not be pulled out of the sockets. See
Figure
Connecting iSCSI cables
Complete the following steps to connect the iSCSI cables.
•
NOTE: When bending iSCSI cables, keep the radius of the bend to at least
1.2 inches (30 mm) to prevent cracking or breaking the fibre optic
conductor.
•
1. Connect the iSCSI cables from the host systems to the desired iSCSI
ports on the AMS 2100/2300 control unit. Insert the connectors until the
lock snaps into place.
2. Pull all the iSCSI cables into the rack passing them through the opening
for cables on the bottom plate of the rack.
5–52
5-46.
Figure 5-46: Binding Fibre Channel Cables Together.
Figure 5-47: iSCSI Interface Cable Connection Ports
Installation
Hitachi AMS 2100/2300 Storage System Hardware Guide