Temporary Address; Connection Method - Hitachi AMS 2100 Hardware Manual

Temporary address

The temporary address specified by RFC3041 is enabled for Windows Vista.
When connected by IPv6, many temporary addresses may be registered in
the installed PC and the processing time may become long depending on
your system environment. Check the temporary addresses, and if many are
set, disable them.
You can display the status of the temporary address by entering the
following command from the command prompt.
Enter the following command to disable the temporary address:
Enter the following command to enable the temporary address:

Connection method

The following illustration shows an example of a connection between the
AMS 2100/2300 and the computer in which Navigator 2 is installed on the
host computer and not a separate management console.
The following are notes regarding the above illustration:
1. The array uses 2000/tcp and 28355/tcp to communicate with Hitachi
2. The IPv6 multicast of the link local scope is used for the search array by
3. When two or more LAN cards are inserted in the computer to install
The following illustration shows another example of a connection between
the AMS 2100/2300 and the computer in which Navigator 2 is installed on
a separate management console.
7–6
C:\> netsh interface ipv6 show privacy
C:\> netsh interface ipv6 set privacy disable
c:\> netsh interface ipv6 set privacy enable
Storage Navigator Modular 2. When it can be connected directly but
cannot communicate through the router, the router may have blocked
ports. Set the router so that the two-way communication to ports is
allowed.
the IPv6 address. When performing the search array, set up the array
and the computer in which Hitachi Storage Navigator Modular 2 is
installed in the same link.
Hitachi Storage Navigator Modular 2 and each LAN is another segment,
it can only access from the LAN card side specified by the installer.
Configuration
Hitachi AMS 2100/2300 Storage System Hardware Guide