Initial Array Setup - Hitachi AMS 2100 Hardware Manual

Initial array setup

This section describes the procedure to configure the basic settings of an
array. The Array Setup wizard is used to do this.
NOTE: Hitachi Data Systems recommends that you set the IP address
manually. If you set the IP address to be obtained automatically in IPv6,
the IPv6 address is decided by the Ethernet address. Therefore, if the
Control Unit is replaced due to a failure, etc., the IP address will be
changed. To change the time or synchronize with a Network Protocol Time
(NTP) server, use the procedure under
7-53.
1. Click Initial Setup. After a few seconds, the Array Setup wizard
launches. This wizard guides you through the following tasks. Each task
listed here is a link to the detailed explanation that follows,
Introduction
up host ports
>
Introduction
The introduction page lists the tasks that can be completed by this wizard.
Click Next > to continue to the next screen and begin the setup process.
NOTE: Important! The settings you make on the screens in this wizard
are not saved until you complete the wizard settings and select Confirm on
the last Confirm screen in this wizard.
> Set up email alert
> Set up spare drives
Finish
Configuration
Hitachi AMS 2100/2300 Storage System Hardware Guide
Setting the day and time on page
> Set up management ports
> Set up date and time
> Set
> Confirm
7–23