Clients Running Solaris Or Linux; Installation Problems; Starting Navigator 2 - Hitachi AMS 2100 Hardware Manual

6. Click OK to exit the Java Runtime Settings dialog box.
7. Click OK in the Java tab to close the Java Control Panel dialog box.
8. Close the Windows Control Panel.

Clients running Solaris or Linux

If your client runs Solaris or Linux, perform the following procedure:
1. From an XWindows terminal, enter <JRE installed directory>/ bin/
jcontrol to run the Java Control Panel.
2. In the Java Applet Runtime Settings section, click View. The Java
Runtime Settings dialog box appears.
3. In the Java Runtime Parameters field, enter -Xmx192m.
4. Click OK to exit the Java Runtime Settings dialog box.
5. Click OK in the Java tab to close the Java Control Panel dialog box.

Installation problems

If you have problems with the installation or if Navigator 2 does not install
correctly, or does not run after it is installed, please contact Hitachi Data
Systems Technical Support. See
for contact information.

Starting Navigator 2

1. After the software is installed, launch a Web browser on the
management console.
2. Enter the appropriate URL in the address field.
• If you are using http, enter the following URL in the address field:
where <IP address> is the IPv4 or IPv6 address of the management
console.
• <If you are using http, enter the following URL in the address field:
7–16
Figure 7-2: Java Runtime Settings Dialog Box
http://<IP address>:23015/StorageNavigatorModular/Login
https://<IP address>:23016/StorageNavigatorModular/Login
Configuration
Hitachi AMS 2100/2300 Storage System Hardware Guide
Support Contact Information in the Preface