Reregistering The Array - Hitachi AMS 2100 Hardware Manual

Reregistering the array

If you changed the IP address of the array as described in
on page
procedure.
1. Log out of Navigator 2, and close the browser.
2. Restart the browser and launch Navigator 2.
3. Enter the appropriate URL in the address field.
• If you are using http, enter the following URL in the address field:
where <IP address> is the IPv4 or IPv6 address of the management
console.
• <If you are using https, enter the following URL in the address
field:
where <IP address> is the IPv4 or IPv6 address of the management
console.
NOTE: The https URL is invalid immediately after the installation. Refer to
Using SSL on page
When you enter an IPv6 address, you must enclose the URL in brackets []
Example: http://[xxxx]:23015/StorageNavigatorModular
If you have the IPv6 address set to use DHCP and obtain an address
automatically, simply delete the array from the Array List window and add
it back in again.
After a few seconds, the login screen is displayed as shown in the
following figure.
7–30
7-23, you must register the array again. Otherwise, skip this
IP
http://< address>:23015/StorageNavigatorModular/Login
https://<IP address>:23016/StorageNavigatorModular/Login
7-49.
Configuration
Hitachi AMS 2100/2300 Storage System Hardware Guide
Initial array setup