Registering The Array On The Support Website - Hitachi AMS 2100 Hardware Manual

4. Enter the default administrator user ID: system (all lower case).
5. If you changed the administrator password, enter your current
password. Otherwise, enter the default administrator password:
manager, as shown above. After a few seconds, the Array List window
is displayed.
6. In the Array List window, click the checkbox to the left of the name of
the array whose settings you just modified, and click Edit Array. The
Edit Array dialog box is displayed.
7. In the Edit Array dialog box, enter the IP addresses for controller 0 and
controller 1 that you set in the
Array Setup wizard.

Registering the array on the support website

This section describes the procedure to use Navigator 2 to register the array
information on the Hitachi Data Systems Support site.
You must register the array information on the Hitachi Data Systems
support site. This is required if you plan to download firmware, software,
and documentation updates, and for ordering any needed replacement
parts.
NOTE: If the management console is not connected to Internet, write
down the information for registration and register it from a computer that
is connected to the Internet.
Follow these steps to register an array on the support site:
1. Ensure that the management console has a connection to the internet.
2. Click the link below or open a browser and enter the following URL to
access the Hitachi Data Systems Support Website login page.
http://support.hds.com.
Set up Management Ports
Configuration
Hitachi AMS 2100/2300 Storage System Hardware Guide
screen in the
7–31