Qsfp+ Port - NEC QX-S6648XP-6Q Installation Manual

Installation Guide
QX-S6600 Series Ethernet Switches
Caution:
10G SFP+ side minimum bend radius of 40G QSFP+/10G SFP+ Copper cable is 35mm.
40G QSFP+ side minimum bend radius is 50mm. When not securing minimum bend radius
of a cable, there is damage of a cable or a possibility that performance deterioration forms.
Don't bend a cable below the minimum bend radius.
Figure 10-4 Minimum bend radius of 40G QSFP+/10G SFP+ Copper cable Minimum bend radius of the 10G
SFP+ side (the left side) and 40G QSFP+ (the right side) of 40G QSFP+/10G*4 SFP+ change copper wire

10.1.5 QSFP+ port

QX-S6600 Series provide QSFP+ ports. You can plug the QSFP+ transceiver modules in
Table 10-8 and the QSFP+ cables in Table 10-9 into the SFP+ ports as needed.
The QSFP+ cables available for the QX-S6600 Series are 40 Gbps SFP+ Copper cables,
as shown in Figure 10-5. The SFP+ cables available for the QX-S6600 Series are 40G
QSFP+/10G*4 SFP Copper cables, as shown in Figure 10-3.
Transceiver module
model
40GBASE-SR4-QSFP+
Table 10-8 QSFP+ transceiver modules available for the QX-S6600 Series
Central wavelength
(nm)
850
cable
Fiber diameter
Connector
(µm)
Multi-mode,
50/125, OM3
MPO
Multi-mode,
50/125, OM4
10-8
10 Appendix C Ports and LEDs
Max transmission
distance
100 m
150 m