Installing/Removing A Sfp/Sfp+/Qsfp+ Module; Installing A Sfp/Sfp+/Qsfp+ Module; Removing A Sfp/Sfp+/Qsfp+ Module - NEC QX-S6648XP-6Q Installation Manual

Installation Guide
QX-S6600 Series Ethernet Switches

Installing/Removing a SFP/SFP+/QSFP+ module

WARNING:
Do not touch the connector terminal when you insert and remove the SFP/SFP+/QSFP+ module.
You can install some SFP/SFP+/QSFP+ modules for QX-S6600 Series as needed. For
more information about a SFP/SFP+/QSFP+ module available for the switches, see
"Appendix C Ports and LEDs "

3.6.1 Installing a SFP/SFP+/QSFP+ module

CAUTION:
To prevent damage to the connectors inside the switch chassis, insert a SFP/SFP+/QSFP+ module gently. If
you encounter a hard resistance while inserting a SFP/SFP+/QSFP+ module, pull out a SFP/SFP+/QSFP+
module and insert it again.
WARNING:
Do not remove the dust-proof cover before connecting a fiber optic-cable.

Do not connect a fiber optic-cable before inserting a SFP/SFP+/QSFP+ module.

To install a SFP/SFP+/QSFP+ module into the switch:
1) Wear an ESD-preventive wrist strap and make sure it makes good skin contact and is
well grounded.
2) Insert the transceiver with the lever raised until you hear a click.

3.6.2 Removing a SFP/SFP+/QSFP+ module

To remove a SFP/SFP+/QSFP+ module into the switch:
1) Wear an ESD-preventive wrist strap and make sure it makes good skin contact and is
well grounded.
3-24
3 Installing the switch