Table of Contents
Advertisement
4-2. Installing/Removing SFP+ Module
After the 8G FC Switch is installed in the Blade Enclosure (SIGMABLADE), install SFP+ modules
on external ports to connect with fibre channel peripherals. The 4/8G SFP+ module to the
attachment in the product and the N8406-041 4/8G SFP+ module are only available.
IMPORTANT:
For N8406-040, four external ports, or ports 17, 18, 19 and 20 are available. Ports 21,
22, 23, and 0 are unavailable.
For N8406-042, eight external ports, or ports 17, 18, 19, 20, 21, 22, 23 and 0, are
available.
If an 8G FC Switch with SFP+ modules installed are stored or carried, always put the
dust covers attached to the SFP+ modules on them to protect the FC connectors from
dust.
Installation Procedure
Remove the cap to the 8G FC Switch.
1.
IMPORTANT:
Keep the removed the cap for future use.
There is't the caps for ports 17 and 18 at N8406-040.
There is't the caps for ports 17, 18, 19 and 20 at N8406-042.
To install an SFP+ module on the 8G FC Switch, insert it to an SFP+ port to the depth.
2.
N8406-040/042 8G FC Switch
IMPORTANT:
Insert the connector to the SFP slot until it clicks, without pulling down the lever. If you
insert with the lever pulled down, a communication failure may occur.
Do not view laser directly.
The 4/8G SFP+ module to the attachment in the product and the N8406-041
4/8G FC SFP+ module confirm to laser safety standard class 1. However, do not
view the laser within a short distance of up to 20 cm. Failure to follow this
instruction may have bad influence on your pupils. Do not look in the port of each
SFP+ module during operation. If an SFP+ module is not connected with an
optical fiber cable, always put the attached dust cover (rubber cap) on the
connector terminal of the SFP+ module to protect it.
SFP+ module
SFP+ port
WARNING
Insertion
direction
- 136 -
Advertisement
Table of Contents
