Table of Contents
Advertisement
Setting Time Server
Type "tsclockserver" command on the console screen.
1.
NOTE:
Any commands used on the switch console should be specified with lowercase
letters.
Check the current setting of the time server.
2.
<Checking time server setting>
ALE044120T2:admin> tsclockserver
Active NTP Server
Configured NTP Server List LOCL
ALE044120T2:admin>
NOTE:
"LOCL" appears if the time server is not set.
Set the time server by using the "tsclockserver" command on the console screen.
3.
Type "tsclockserver xxx.xxx.xxx.xxx" to set the time server.
Value "xxx.xxx.xxx.xxx" is the IP address of the time server to be set.
<Time server setting>
ALE044120T2:admin> tsclockserver 192.168.1.1
Updating Clock Server configuration...done.
ALE044120T2:admin>
NOTE:
For the IP address of an available time server, contact your system administrator.
After setting, type "tsclockserver" command on the console screen to check the setting.
4.
<Checking time server setting>
ALE044120T2:admin> tsclockserver
192.168.1.1
ALE044120T2:admin>
NOTE:
The IP address of the time server being set appears.
LOCL
- 154 -
Advertisement
Table of Contents
