Table of Contents
Advertisement
Appendix: Saving/Restoring Setting Values
Saving/Restoring Setting Values
Information set on the 8G FC Switch can be saved or reset by using the configupload or
configdownload command.
IMPORTANT:
To run commands saving the setting of the 8G FC Switch, an FTP server is required
additionally. Prepare a proper FTP server before saving.
The configupload and configdownload commands do not change the name and IP
address of the 8G FC Switch. After executing configdownload, change them by using
respective commands.
NOTE:
Saving of settings on 8G FC Switch is required in system recovery including device
replacement due to a system fault. If a new 8G FC Switch is installed or some setting
on an 8G FC Switch is changed, save the settings on the 8G FC Switch.
Transmit setting file to FTP server.
1.
Using the "configupload" command allows a setting file to be transmitted to the FTP server.
Format of "configupload" command
configupload
Protocol (scp, ftp, local) [ftp]:
Server Name or IP Address [host]:
User Name [user]:
Path/Filename [<home dir>/config.txt]:
Password:
NOTE:
The values in angle brackets ([ ]) are defaults.
← Command
← Transmission protocol
← IP address of FTP server
← User name of FTP server
← File name
← Password of FTP server
- 188 -
Advertisement
Table of Contents
