NOTE:
■
After network setting is completed, the network daemon program in the
firmware of the FC Switch Module automatically restarts the FC Switch
Module. The network setting is enabled just after the auto restart.
■
To access to an FC Switch Module via network, some settings may be
required in the Blade Enclosure (SIGMABLADE). For the settings, refer to the
User's Guide of the EM Card.
■
"Fibre Channel IP Address" and "Fibre Channel Subnetmask" are unavailable.
Do not change their settings.
If some network settings are changed during system operation, an error
■
message may appear on a log of the host connecting with the FC Switch
Module at the restart by the network daemon program.
- 145 -