NEC SigmaBlade N8406-040(F) User Manual page 127

(2) External Ports
The SFP+ ports enable the 8G FC Switch to connect with fibre channel devices.
The 8G FC Switch is equipped with eight SFP+ ports. However, available ports vary depending on
the type. See the table below for the available ports.
External Port
Port 17 - 20
Port 21 - 23
Port 0
IMPORTANT:
The SFP+ module can be installed on an unavailable SFP+ port. However, the
SFP+ module cannot connect the 8G FC Switch with a fibre channel device.
(3) Internal Ports
The internal ports allow the 8G FC Switch to connect to fibre channel controllers inserted to
Mezzanine slots on the CPU blades in a Blade Enclosure (SIGMABLADE).
The 8G FC Switch is equipped with 16 internal ports. However, available ports vary depending on
the type. See the table below for the available ports.
IMPORTANT:
The slot number of the CPU blade to which a specific internal port is connected is
fixed. Changing the number is not allowed. For details, refer to the User's Guide of
the Blade Enclosure (SIGMABLADE).
In the case of using a CPU blade which uses only one CPU blade slot or two CPU blade
slots located side by side:
In the case of SIGMABLADE-M
Internal Port
Port 1
Port 2
Port 3
Port 4
Port 5
Port 6
Port 7
Port 8
Port 9
Port 10
Port 11
Port 12
Port 13
Port 14
Port 15
Port 16
Available/unavailable
N8406-040
√
–
–
Available/unavailable
N8406-040
√
√
√
√
√
√
√
√
–
–
–
–
–
–
–
–
- 127 -
N8406-042
√
√
√
Connected CPU blade
Slot 1
Slot 2
Slot 3
Slot 4
Slot 5
Slot 6
Slot 7
Slot 8
Slot 9
Slot 10
Slot 11
Slot 12
Slot 13
Slot 14
Slot 15
Slot 16