NEC SigmaBlade N8406-040(F) User Manual page 132

According to the User's Guide of the Blade Enclosure (SIGMABLADE), remove the blank cover on
2.
the switch module slot into which the 8G FC Switch will be inserted.
NOTE:
For the procedure of removing a dummy module or blank cover from the switch
module slot of the Blade Enclosure (SIGMABLADE), refer to the User's Guide
attached to Blade Enclosure (SIGMABLADE).
Keep the removed the blank cover for future use.
Unlock the stopper of the ejector on the 8G FC Switch to unlatch the ejector.
3.
NOTE:
Press the stopper lightly in the right direction to unlock the stopper. Then the
ejector is unlatched.
According to the User's Guide of the Blade Enclosure (SIGMABLADE), install the 8G FC Switch in
4.
the Blade Enclosure (SIGMABLADE).
IMPORTANT:
Do not hold the ejector to install the 8G FC Switch in the Blade Enclosure. Hold the 8G
FC Switch itself and insert it into the slot. The ejector may break off, causing injury if the
8G FC Switch falls.
- 132 -