Table of Contents
Advertisement
Item
Displayed data
Port
0 - 23
Media
--
Cu
id
Speed
AN
4G
8G
N4
N8
State
No_Module
Online
No_Sync
In_Sync
No_light
Laser_Flt
Port_Flt
Diag_Flt
NOTE:
You can identify the fault location by comparing the information shown by
"switchshow" command with the actual connection.
IMPORTANT:
The state messages for the internal and external ports unavailable to N8406-040 are
"No_Sync Disabled (Persistent)" and "No_Module (No POD License) Disable,"
respectively.
A hardware error occurs in each status with asterisk mark (*) in the table above.
Maintenance work is required for recovery. Contact your service representative.
Information displayed by "switchshow" command
Description
Correspond to the port numbers of the 8G FC Switch.
No SFP+ module is installed on ports (for external ports only).
Media of copper type is installed. (The value is fixed for internal ports).
An SFP+ module of fibre type is installed.
The port data rate is auto negotiated.
The port data rate is fixed to 4G bps.
The port data rate is fixed to 8G bps.
The port data rate is auto negotiated to 4G bps.
The port data rate is auto negotiated to 8G bps.
No SFP+ module is installed.
The Fibre channel device is linked up normally.
Either of the following two messages appears in normal linkup status
depending on the port topology of the connected fibre channel device:
"Online F-Port WWN" in fabric connection or
"Online L-Port 1Pubric" in loop connection.
The SFP+ module receives optical signals, but the signal is not in
synchronized state.
The SFP+ module receives optical signals and the signal is in
synchronized state, but the Fibre channel device is not linked up
normally.
The SFP+ module does not receive optical signals.
The SFP+ module has output laser Fault.*
The SFP+ port is in fault state.
The SFP+ port is disabled because of detecting error by self-diagnosis.*
- 147 -
Advertisement
Table of Contents
