Table of Contents
Advertisement
Enabling Configuration
Enable created configuration. Only a single configuration can be enabled at a time.
1) Validating configuration
Use the "cfgenable" command to enable a configuration.
Format of "cfgenable" command
cfgenable
(1) cfgName:
Specify a zone configuration name with it enclosed by double quotation marks (").
IMPORTANT:
If you try to enable configuration by using the "cfgenable" command, the message
asking whether the configuration is enabled appears. Type "y" if the configuration is
enabled. Type "n" if not.
Message sample:
Type "cfgshow" command on the console screen.
1.
ALE044120T2:admin> cfgshow
Defined configuration:
cfg:
cfg1
zone: zone1 1,0;1,1
zone: zone2 1,2;1,3
zone: zone3 1,4;1,5
zone: zone4 1,6;1,7
Effective configuration:
Effective configuration:
no configuration in effect
ALE044120T2:admin>
NOTE:
Confirm that the configuration to be enabled appears in "Defined Configuration".
Use the "cfgenable" command to enable the configuration.
2.
ALE044120T2:admin> cfgenable cfg1
You are about to enable a new zoning configuration.
This action will replace the old zoning configuration with the
current configuration selected. If the update includes changes
to one or more traffic isolation zones, the update may result in
localized disruption to traffic on ports associated with
the traffic isolation zone changes
Do you want to enable 'cfg1' configuration (yes, y, no, n): [no] yes
zone config "cfg1" is in effect
Updating flash ...
ALE044120T2:admin>
"cfgName"
(1)
Do you want to enable 'cfg1' configuration (yes, y, no, n): [no]
zone1; zone2; zone3; zone4
- 180 -
Advertisement
Table of Contents
