SYSTEM DESCRIPTION
4. FEATURE DESCRIPTION
As shown in
Figure
station in the UCD group or Hunting group.
When terminating a call to the VMS, the AP00 sends a call connection status information to the VMS through
the MCI. If the ANI information is sent from the network, the ANI information can be added to the call connec-
tion status information by the system data programming (this feature is not available when the call is received
from the CCIS trunk to the VMS.).
When the station/trunk/Attendant leaves a message in the VMS, the VMS sends a Message Waiting lamp on
data for the appropriate station through the PBX. After the station retrieves the messages, the VMS sends a Mes-
sage Waiting off data for the appropriate station through the PBX.
When accessing the VMS, the connecting patterns shown in
Single Line
Telephone
term
D
(Call Forwarding Set)
VMS
Message Waiting
lamp on/off data
CHAPTER 2
Page 6
Revision 1.1
2-2, a direct call or a forwarded call from a station/trunk/Attendant terminates to the VMS
LC
DLC
1
LC
LC
UCD Group
or Hunting Group
Figure 2-2 MCI Feature Description
Addendum-001
Table 2-2
PBX
TDSW
2
MP
RS-232C Cable
ND-45895 (E)
JULY, 1997
are possible.
TRK
NETWORK
Connection
AP00
Status data
1
: Forwarded Call from a trunk
2 : Direct Call from a station