Programming Procedure - NEC Neax 2000 IVS System Manual

SYSTEM DATA PROGRAMMING

3. PROGRAMMING PROCEDURE

Initialize the AP using the procedure described in
accordance with Feature Programming.
For command details, refer to the Command Manual.
After all system data is assigned, set the SW1 switch of PN-AP00 as shown below to protect the data.
In the programming procedures described, the following symbolic conventions are used:
st
(1) : 1
nd
(2) : 2
: Initial Data
With the system data clear commands (CM00, CM01), the data with this marking is automat-
ically assigned for each command.
INITIAL : System Initialization
After entering the data, system initialization of the MP card is required.
AP INITIAL
: AP Initialization
After entering the data, AP initialization is required. (Toggle the Make Busy switch on the
AP card to UP and then DOWN.)
CHAPTER 4
Page 32
Revision 1.0
SW 1
4
3
2
1
ON
Data
Data
ND-45895 (E)
section 3.1, and perform system data feature programming in
: POSITION TO BE SET