Ap Initialization - NEC Neax 2000 IVS System Manual

3.1 AP Initialization

When setting up the MCI system, first do the following AP initialization.
START
CM05 Assign a Slot Number to the PN-AP00 card.
The slot number to be assigned must coincide
with the value set by the SENSE switch on
the PN-AP00 card.
On the PN-AP00 card, set SW1 switch as
shown below.
ON
CMD101
Load the initial data into the PN-AP00.
On the PN-AP00 card, set the SW1 switch as
shown below:
ON
Note: After changing the SW1 switch as shown
END
DESCRIPTION
SW 1
4
3
: POSITION TO BE SET
2
1
SW 1
4
3
: POSITION TO BE SET
2
1
above, MP reset is required.
ND-45895 (E)
Addendum-001
JULY, 1997
SYSTEM DATA PROGRAMMING
(1) Slot No. (04-15)
(2) 04: PN-AP00 card
INITIAL
(1) 0000
(2) CCC
Note
DATA
CHAPTER 4
Page 33
Revision 1.1