Data Programming For Mci - NEC Neax 2000 IVS System Manual

SYSTEM DATA PROGRAMMING

3.2 Data Programming for MCI

In addition to the programming of Call Forwarding (All Calls/Busy Line/No Answer) or Split Call Forwarding
(All Calls/Busy Line/No Answer) and Uniform Call Distribution or Station Hunting (Circular/Terminal/Secre-
tarial), do the following programming. (For details on programming these features, refer to the Feature Program-
ming Manual.)
START
Provide the VMS with MCI.
CM08
Specify MSG display on the D
Note: When the 2nd data is set to 0, "MSG" is
Specify Message Waiting control from VMS
with MCI to all stations.
Specify whether Message Waiting service
from the VMS is provided for the called sta-
tion when a forwarded call is terminated to
the VMS via CCIS.
Provide Message Waiting service for a station
CM13
with an MW lamp.
Provide VMS service for a station port inter-
face with the VMS (VMS station).
Provide Momentary Open for a station port
interface with the VMS (VMS station), as re-
quired.
A
CHAPTER 4
Page 34
Revision 1.0
DESCRIPTION
term
displayed (the number of messages is not
displayed).
ND-45895 (E)
(1) 443
(2) 0: VMS with MCI
. (1) 025
(2) 0/1
(1) 444
(2) 0/1
(1) 376
(2) 0/1
• YY=03
(1) X-XXXX: Station No.
(2) 0: To be provided
• YY=10
(1) X-XXXX: Station No. (VMS station)
(2) 0: To be provided
• YY=22
(1) X-XXXX: Station No. (VMS station)
(2) 0: To be provided
DATA
: Available/Not Available
: Available/Not Available
: To be provided/Not to be
provided