Message Waiting Control Message Format (Vms To Pbx); Figure 5-4 Message Waiting Lamp Control Message Format (Vms To Pbx) - NEC Neax 2000 IVS System Manual

3.3 Message Waiting Control Message Format (VMS to PBX)

This message format is used to control the Message Waiting lamp on a called station from a VMS.
The data is sent to the PBX from VMS in the format shown in
When using Tenant No.:
1
Byte No. 1 2 3
Data S S U
(ASCII)
T A A
X
When not using Tenant No.:
2
Byte No. 1 2 3
Data S S U
(ASCII)
T A A
X
*For details on Station 1 and Station 2, refer to

Figure 5-4 Message Waiting Lamp Control Message Format (VMS to PBX)

4 5 6 7 8 9
E
I
Station 1*
MW Lamp status
0: OFF
1: ON
5: OFF
4 5 6 7 8 9
E
I
Station 1*
MW Lamp status
0: OFF
1: ON
5: OFF
Table
ND-45895 (E)
Addendum-001
JULY, 1997
Figure 5-4.
10 11 12 13 14 15
Station 2*
10 11 12 13 14 15
Station 2*
5-4.
SPECIFICATIONS
16 17 18
E
T
X
16 17 18
E
T
X
Tenant No.
(Unused)
CHAPTER 5
Page 41
Revision 1.1