Important Notice - ABB UMC100.3 Manual

U M C 1 0 0 . 3 U N I V E R S A L M O T O R C O N T R O L L E R M A N U A L
2
—

Important notice

Target group
This description is intended for use by trained specialists in electrical installation and control and automation engineering,
who are familiar with the applicable national standards.
Safety requirements
The responsible staff must ensure that the application or use of the products described satisfy all the requirements for safety,
including all the relevant laws, regulations, guidelines and standards.
Using this Handbook
Symbols
This technical document contains markers to point the reader to important information, potential risks and precautionary
information The following symbols are used:
Symbol to indicate a potentially dangerous situation that can cause damage
to the UMC or connected devices or to the environment
Symbol to indicate important information and conditions.
Symbol that indicates a potentially dangerous situation that can cause personal injury
—
Abbreviations
UMC100.3 Universal Motor Controller; sometimes just called UMC
DCS Distributed Control System
PLC Programmable Logic Controller
GSD Device description file for PROFIBUS networks
EDS Device description file for DeviceNet and EtherNet/IP™ networks
FDT/DTM Device driver technology for field devices. Specified from the FDT group
NC / NO Normally closed / Normally open
FBP FieldBusPlug is the name for a group of products which allows to connect ABB low voltage control products to different fieldbusses
CI Communication Interface e.g. PDP32 for PROFIBUS
—
Related Documents
Technical Documentation
DTM manual for FBP devices
Manual of the custom application editor
Document No.
2CDC192012D02xx
2CDC135034D02xx