Adjusting Parameters; Adjusting A Numerical Value; Selecting An Option From A List - ABB UMC100.3 Manual

U M C 1 0 0 . 3 U N I V E R S A L M O T O R C O N T R O L L E R T E C H N I C A L D E S C R I P T I O N
108

Adjusting Parameters

Adjusting a numerical value

This type of dialog allows a numerical value to be specified within the given limits. The single digits must be defined from right to
left. If the last digit was reached the right hot key changes from 'Next' to 'Save'. When pressing 'Save' the specified value is stored
in the UMC. The mask can be exited at any time with the Cancel button (left hot key). In this case the changes are discarded.
The following example shows how to set the nominal motor current I
To change the digit use the up/down keys. As it is not possible to enter a value outside the given limits start editing the first digit
by pressing the up button. If you reach 10, a 0 is displayed in the first digit and a 1 in the second digit. Press the left hot key now to
go to the next digit.
Increase value
Cancel edit

Selecting an option from a list

This type of dialog allows an item to be selected from a given list of options. With the up/down keys you can scroll through the list.
The slider on the right shows the current position within the list. Pressing 'Select' chooses the currently marked item (inverted).
Pressing 'Cancel' exits the dialog and discards the selection.
Selected
option
Previous option
in the list
Cancel editing
.
e1
Last digit
modified
Min/max value
Decrease value
Next position
Slider indicates position
within the given options
Next option in list
Select option
Save changes