Command Data For Softstarter; Timing Diagram - ABB UMC100.3 Manual

U M C 1 0 0 . 3 U N I V E R S A L M O T O R C O N T R O L L E R T E C H N I C A L D E S C R I P T I O N
92
—

Command Data for Softstarter

Word Byte
0
0
1
2
1
3
2 4, 5
3 6, 7
Controlled by the UMC100 if configured as fault output.
1)
The table above represents the data allocation as realised with the built-in standard applications. It may differ for
customer-specific applications!

Timing Diagram

Commands
(received
telegram)
DO0 (Contactor For)
UMC outputs
DO2 (Softstarter On/O )
UMC internal Signal
Softstarter
Monitoring signals
(telegram)
functions disabled
• Opposite direction only possible after OFF and after the reverse lock-out time has elapsed.
• Restart in the same direction without consideration of the Reverse lock-out time.
Related parameters
• Reverse Lockout Time
• YD-Starting-Time (used as ramp-up time if no by-pass signal available)
• Delay 1 / Delay 2 (default value set, can be changed only in the custom application editor)
• Checkback delay time
• Checkback
Bit 7 Bit 6
- Fault Reset
- -
Remaining data see section Parameters and Data Structures on a Fieldbus
RUN FORWARD
OFF
Delay1
Check Current
Ramping
Bypass signal DI0
(optinal)
RUN FORWARD
OFF
Listed protection
Bit 5 Bit 4
Auto Mode Prepare
Emergency
Start
- DO3
(24VDC) 1)
YD-Time
Bit 3 Bit 2
- Run
Forward
- -
Delay2
Bit1 Bit 0
Off Run Reverse
- -