ABB PST30 Installation And Maintenance Manual page 37

Top level
Settings
Local Control
Event Log
Status Information
Reset Events
Figure 22: Start/Stop menu
Top level
Settings
Local Control
Event Log
Status Information
Reset Events
Figure 23: Jog menu
Top level
Settings
6
Local Control
Event Log
Status Information
Reset Events
Figure 24: DOL start menu
6.6
1SXU 132 021 M0201
Chapter 6
Human-Machine nterface (HM)
6:2.4.1 Start/Stop the motor
Start
Enter the Start/Stop menu, Figure 22.
Start / Stop
Select Start. The motor will now start and run according to the set parameters.
Jog
Stop
DOL Start
Select Stop. The motor will stop according to the set parameters. It is possible to press the stop
command during the start ramp if necessary.
6:2.4.2 Jog
Enter the Jog menu, Figure 23.
Select Jog. The motor will start and accelerate to rated speed according to the set parameters as
long as the Jog command is activated.
Start / Stop
The motor stops immediately as soon as the command is released.
Jog
DOL Start
6:2.4.3 DOL start
(PSBT370...1050 only)
Start / Stop Start from the softstarter
Jog If necessary, the motor can be started DOL (Direct On Line/across the line) with the integrated by-
pass contactor.
DOL Start
Select the DOL start menu, Figure 24.
Select DOL start to close the integrated by-pass contactor.
Select Stop to open the contactor.
!
The rated motor current must never exceed the AC-3 rating of the integrated by-pass contactor.
See Chapter 3 for AC3 ratings.
Figure 25: Connection when the contactor is operated
from the keypad (factory wiring).
Warning!
100-250V
50/60 Hz
Figure 26: Connection when the by-pass contactor is operated
separately (emergency DOL)
Low Voltage Products & Systems
ABB nc. • 888-385-1221 • www.abb-control.com