ABB PST30 Installation And Maintenance Manual page 53

Low Voltage Products & Systems
ABB nc. • 888-385-1221 • www.abb-control.com
Chapter 7
Settings and configuration
Frequency fault type of operation (Freq F Op)
Select what operation should be initiated if the frequency fault occurs (out of range):
Stop–M
Stop–A
Press Store to save the selected operation.
Heat sink type of operation (HS Temp Op)
Select what operation should be initiated if an over-temperature occurs:
Stop–M The motor will stop and a manual reset is required.
Stop–A The motor will stop and an automatic reset is performed.
Press Store to save the selected operation.
Shorted SCR type of operation (SCR SC Op)
Select what operation should be initiated if a fault occurs with shorted thyristor:
Stop–M The motor will stop and a manual reset is required.
Stop–A The motor will stop and an automatic reset is performed.
Press Store to save the selected operation.
By-pass doesn't open operation
Select what operation should be asserted if the contactor does not open:
Stop–M The motor will stop and a manual reset is required.
Stop–A The motor will stop and an automatic reset is performed.
Press Store to save the selected operation.
By-pass doesn't close operation (BP Open Op)
Select what operation should be asserted if the contactor does not close:
Stop–M The motor will stop and a manual reset is required.
Stop–A The motor will stop and an automatic reset is performed.
Press Store to save the selected operation.
Fault Connection, Fault Open SCR, Fault Line Side and Fault Intern
Selected operation for the faults listed above is always:
Stop–M The motor will stop and a manual reset is required.
Stop–A The motor will stop and an automatic reset is performed.
Press Store to save the selected operation.
The motor will stop and a manual reset is required.
The motor will stop and an automatic reset is performed.
7
7.15
1SXU 132 021 M0201