Logic Editor Online Help - ABB COM600 series 5.1 User Manual

1MRS756738
3.3.6.
COM600 series 5.1
Logic Processor User's Manual
2. Select Online from the menu bar in Logic Editor, and click Login to connect to
Logic Processor in COM600. Then
a. Further prompts should appear to automatically download the application. Click
Yes and continue.
b. If not, select Online Menu and click Download to download PLC Application.
Figure 3.3.5-1 Login to Logic Processor
3. After successful download of PLC Application, start the application so that it gets
into running/executing state. To start PLC Application, select Debug from the menu
bar in Logic Editor, and click Start. After PLC Application has started, the status
bar in Logic Editor shows RUN in green.
Once PLC Application has been successfully downloaded and is executing in Logic
Processor, the connection from Logic Editor can be terminated by logging out of the
Device. This should not affect the running state of the PLC Application in Logic Pro-
cessor.
To terminate the Logic Editor session and close it:
1. Select Online from the menu bar in Logic Editor, and click Logout to disconnect
Logic Editor from Logic Processor.
2. Close Logic Editor Application by clicking the window close button. Save Project
on close if prompted.

Logic Editor Online Help

Describing fully the use of Logic Editor (CoDeSys Development System) and all of its
functionality is outside the scope of this document. When in doubt, resort to the online
help available in Logic Editor. To launch online help in Logic Editor, select Help from
the menu bar in Logic Editor, and click Contents.
Login_to_Logic_Processor.png
23