Wireless Lan Error Codes - Brother ADS-1250W Online User's Manual

Home > Network > Technical Information for Advanced Users

Wireless LAN Error Codes

Related Models: ADS-1700W
If the LCD displays an error message, locate the message in the table and use the recommended solution to
correct the error.
Error Message Problem and Recommended Solutions
Connection The wireless access point/router cannot be detected.
Fail
1. Check the following:
2. If you manually entered the SSID and security information (SSID/authentication method/
Two or more wireless access points that have WPS enabled are detected.
•
•
Wrong Network The security information (SSID/Network Key (Password)) is incorrect.
Key
Confirm the Network Name (SSID) and the Network Key (Password).
If your router uses WEP encryption, enter the Network Key (Password) used as the first WEP
key. Your Brother machine supports the use of the first WEP key only.
Related Information
• Technical Information for Advanced Users
• Make sure the wireless access point/router is powered on.
• Move your machine to an obstruction-free area, or closer to the wireless access point/
router.
• Temporarily place your machine within about 3.3 feet (1 meter) from the wireless access
point/router when you are configuring the wireless settings.
• If your wireless access point/router is using MAC address filtering, confirm that the MAC
address of the Brother machine is allowed in the filter.
encryption method/Network Key (Password)), the information may be incorrect.
Confirm the SSID and security information, and re-enter the correct information as
necessary.
This device does not support a 5 GHz SSID/ESSID and you must select a 2.4 GHz SSID/
ESSID. Make sure the wireless access point/router is set to 2.4 GHz or 2.4 GHz/5 GHz
mixed mode.
Confirm that only one wireless access point/router within range has the WPS method active
and try again.
Try again after a few minutes to avoid interference from other access points.
> Wireless LAN Error Codes
111