Brother ADS-1250W Online User's Manual page 160

Difficulties
Cannot enter the IP
address and Subnet
Mask.
(ADS-1700W)
The computer has
detected a USB flash
drive.
I want to restrict to
change setting from
Remote Setup.
(ADS-1700W)
I want to prevent users
from changing settings
using Remote Setup.
(ADS-1700W)
Other Difficulties
Difficulties
The machine is in Sleep
Mode (power save
mode).
The machine is not
turned on.
Your computer cannot
find the machine via
USB interface.
Related Information
• If You Are Having Difficulty with Your Machine
• Clean the Scanner and Rollers
• Secure Function Lock 3.0
• Acceptable Documents
• Card Jam
• Clean the Sensors
• Brother iPrint&Scan for Windows
• Configure Scan to Workflow Settings Using Brother iPrint&Scan
Cause
"000.000.000.000." has already been
entered.
A USB flash drive is inserted into the
machine and the computer is
connected to the machine using a
USB cable.
-
-
Cause
The machine is idle and the amount
of time specified by the Sleep Mode
setting has elapsed.
The machine was plugged in within
60 seconds after pulling out the plug.
The scanner driver is not installed.
®
and Mac
Suggestions
Press the button to delete the entered
information, and then enter the correct information.
The computer detects the USB flash drive that is
inserted into the machine. Remove the USB flash
drive so that the computer does not detect it.
When you set Security Function Lock or Setting
Lock on, Remote Setup cannot start by any user.
When you turn on the Secure Function Lock or
Setting Lock, the users cannot use Remote Setup.
Suggestions
Do one of the following:
• Press .
• Press . (ADS-1700W)
• Scan using your computer.
• Open the Front Cover.
• Load your document.
• Touch the screen. (ADS-1700W)
• Insert/disconnect the USB flash drive.
• Insert/disconnect the USB cable from the
machine or PC.
Turn off the machine, wait 60 seconds, and then
turn it on again.
Install the scanner driver.
156