Lifting Of Loads - ABB TPS48-H33 Operation Manual

Operation Manual / 2 Safety / TPS..-H
1 Safety
1.10

Lifting of loads

Suspended loads
Loads that are not attached according to regulations can cause injury to per-
sonnel or fatal accidents.
WARNING
Loads must always be fastened to properly functional lifting gear with a

sufficient load limit.
Pay attention to the correct attachment of loads on the crane hook.

People must not stand beneath suspended loads.

Wear safety gloves to protect against mechanical hazards.
Wear safety helmet.
Figure 3: Attachment of loads on the crane hook
Figure 4: Attachment angle
If there are two or more suspension points, the attachment angle of 45° must not be exceed-
ed. This prevents excessive loading due to diagonal pull.
Before looping around the components of the turbocharger, let them cool down (maximum

80 °C).
Attach components of the turbocharger as described in the respective action steps.

Use a suitable edge guard if there are sharp edges.

The assembly devices must be completely screwed in and must not unscrew during use.

Use assembly devices only for the described applications.

Put down dismantled components of the turbocharger in such a way that they cannot tip

over.
© Copyright 2016 ABB. All rights reserved. HZTL4026_EN
Page 9 / 17
Revision B May 2016