Monitoring Operation; Oil Pressure, Oil Temperature; Table 6 Lubricating Oil Pressure, Oil - ABB TPS48-H33 Operation Manual

Operation Manual / 4 Product description / TPS44-H.. - TPS52-H..
4

Monitoring operation

4 Monitoring operation
4.1

Oil pressure, oil temperature

Lubricating oil pressure, oil inlet
Assuring lubricating oil pressure
Serious damage to engine or property can result from missing or insufficient
lubricating oil supply.
CAUTION
The lubricating oil pressure must be monitored during operation and the

necessary pressure assured at the oil inlet.
Status for operation
Normal operation
Engine start: Cold oil, admissible for max. 15 minutes
Engine idling
Pre-lubrication and post-lubrication (engine stopped)
Warning signal: (n ≥ 0.5 x n
Alarm signal: Not admissible. Stop the engine immediately.
Table 6: Lubricating oil pressure, oil inlet
For monitoring the lubricating oil pressure, ABB Turbo Systems recommends installing an "M"
manometer immediately before the turbocharger. If the pressure is controlled electronically,
the appropriate signals are to be triggered at the warning and alarm values.
*) If the drain pipe is vented, the measuring point for lubricating oil temperature can be in-
stalled at the outlet in the vent tank. Otherwise the measurement should be taken in the drain
pipe as close to the turbocharger as possible.
Oil orifice at the oil inlet
To limit the oil flow rate through the turbocharger to the admissible values
with the engine at 100% load, an oil orifice is mandatory or has already been
NOTICE
fitted at the oil inlet of the bearing casing if the oil inlet pressure is > 3 bar.
© Copyright 2016 ABB. All rights reserved.
)
Bmax
01 Turbocharger contact surface
02 Oil inlet
03 Oil outlet
M Oil pressure measuring point
T Oil temperature measuring point
HZTL4037_EN
Page 23 / 99
Pressure at oil inlet [bar]
2.0 < p ≤ 4.5
oil
< 8.0
0.5 < p ≤ 2.5
oil
0.5 < p ≤ 1.0
oil
< 1.25
< 0.6
Revision A August 2016