ABB TPS48-H33 Operation Manual page 73

Operation Manual / 4 Product description / TPS44-H.. - TPS52-H..
7 Periodic maintenance work
7.2.3 Compressor-end, non-rotating parts
Handling operating materials and supplies
Swallowing or inhaling vapours of operating materials and supplies or con-
tact with them may be harmful to health.
WARNING
Do not breathe in these substances and avoid contact with the skin.

Ensure proper ventilation.

Observe the information in the material safety data sheet for the operating

materials and supplies.
Wear personal protective equipment (PPE) according to the material safe-

ty data sheet.
Comply with local legislation.

Wear safety goggles.
Wear safety gloves to protect against chemical hazards.
Wear a respiratory mask to protect against gases.
The following parts, which are relevant in terms of performance, can be cleaned in accordance
with the description below.
Figure 14: Cleaning the compressor casing, diffuser mechanically
72000 Compressor casing
79000 Diffuser
Steam-clean the above-mentioned components or soak in diesel oil or water with house-

hold cleaning agents. After soaking, remove contamination with a brush.
Dry components completely.

Spray cleaned surfaces with penetrating oil. Do not spray exterior surfaces of the turbo-

charger.
Dispose of contaminated water and cleaning agents in accordance with the information in

the material safety data sheet.
© Copyright 2016 ABB. All rights reserved. HZTL4037_EN
Page 43 / 99
Revision A August 2016