Error Code List; Error Codes For The Mes Interface Module - Mitsubishi Electric Melsec Q Series User Manual

10
TROUBLESHOOTING

10.2 Error Code List

The error code list is shown below.

10.2.1 Error codes for the MES interface module

Error code
0001h
0002h
0041h
to
0044h
0045h
0046h
0047h
0048h
0049h
004Dh
004Eh
0050h
0051h
0055h
0064h
0065h
0066h
0067h
0080h
10
- 7 10.2 Error Code List
10.2.1 Error codes for the MES interface module
Table 10.3 Error codes for the MES interface module
Error name
System error —
No response has been received
Response time-out error
from the other station.
System error —
A processing code that is not
Processing code error
supported was issued.
Station No. specification The specified station number is
error incorrect.
Receive data error Data have not been received.
System error —
The RUN write setting of the
Channel No. error
Ethernet module is disabled.
System error —
Routing parameter error No routing parameter has been set.
Data send error Failed to send the data.
Data receive error Failed to receive the data.
Read size error The read size is not correct.
Description
• Please consult your local Mitsubishi
representative.
• Correct [Access target CPU settings].
• Check the communication cable status
and access target CPU status.
• Correct the response monitoring time
setting.
• Check the routing parameter set for the
CPU(s) on the access route.
• Check the control CPU(s) of the
network module(s) on the access route
to the access target CPU module.
• Check if the access target PLC series
is supported.
modules
• Please consult your local Mitsubishi
representative.
• Check the CPU(s) on the access route.
• Check the station number setting in
[Access target CPU settings].
• Check the CPU(s) on the access route.
• Please consult your local Mitsubishi
representative.
• Check the Ethernet module setting of
the access target CPU.
• Please consult your local Mitsubishi
representative.
• Check the routing parameter set for the
CPU(s) on the access route.
• Check the CPU(s) on the access route.
Action
Section 4.5 (3) Response
monitoring time setting (Switch 3
(Lower byte))
Section 3.2 (2) Accessible routes
Section 3.2 (1) Accessible CPU
(To the next page)